Why Does The Burner Automatically Go Out After Ignition?

 News     |      2020-06-29 17:51
gas boiler burner

gas boiler burner

In general, the burner will not be put out in use unless it is influenced by environmental factors, such as strong wind, heavy rain and other unpredictable factors.So what causes the ignition to automatically go out?In fact, the influence of small make up is not good all generalize, so introduce the following points.
 

Combustion machine accessories:

 
1. There is no induction problem in the controller of the combustion engine, and the flame signal of the combustion engine cannot be detected, which leads to the failure of ignition.Because induction controller is a kind of ion needle is ultraviolet ray electric eye, so the sensitivity to the flame signal is relatively low.
 
2. Signal line transmission failure
 
3. The process controller is disturbed, resulting in failure
 
4. The ignition flame itself is too weak to ignite the burner.
 
5. Improper operation mode leads to connection errors such as the connection between the zero line and the ground line, and the ground line is not connected stably.
 
6. Fuel gas supply problem, fuel gas supply is less than the combustion port, fuel gas shortage, fuel gas is not pure and so on.
 
7. Failure of temperature sensor in burner parts.
 
8. There are a series of problems with the pump, such as pump sticking, damage and so on.
 
9. Computer board failure of burner
 
10. Failure due to excessive temperature
 
Insufficient combustion air volume
 
12. Gas valve is blocked
 
The above is about the combustion machine accessories problem caused by the combustion machine point not to catch fire and use the way to extinguish the influence factors, If you have any questions,just leave your message in comments area.

Message Feedback