The oil burner is installed on the stove. During combustion debugging, if there is black smoke, gradually open the big damper; if there is white smoke (water vapor), gradually close the small damper; if the damper is small to smokeless, the burner is burning normally, and then work Turn off the power for a few minutes and close it, stop it for a few minutes and open it again to investigate whether the combustion and combustion are normal. If there is no abnormal phenomenon after repeated several times, it indicates that the oil burner has been adjusted.
In the commissioning operation, it is necessary for the gas to be careful, safe and efficient. After starting the burner, if the alarm is bright, then at least 20 seconds after the demand ratio, press the reset button again to restart. If the flame length is very short and the color is red, close the conditioning flap at this moment until the flame is slightly yellow and dazzling, its ignition power is strong and powerful, and the flame length is moderate.
If the color of the flame is reddish, its ignition strength is poor, and the fire speed is low, at this moment, the conditioning air door will continue to be opened. Matters to be noted until the flame is slightly yellow and weak and dazzling, its ignition power is strong and the fire speed is moderate That's it. Before starting the burner, please open the conditioning air door under the body slightly (opening is 1/3 of the full opening), and then turn it on, the fire power of the flame and the speed of the erupting flame.
When the oil burner fails in the secondary combustion process one after another, the oil burner should be shut down to check whether the gas supply system of the Belden burner is normal and the circuit connection is correct. The oil burner can be used to avoid the problem before restarting the combustion. machine. It is forbidden to strike or conflict with a wrench or metal rod in the gas supply pipeline to prevent static electricity or sparks from causing gas explosions.
