Using a burner is easy, but maintaining and maintaining it is hard.If you maintain it well, you can achieve the effect of extending the service life, but if you do not maintain it for a long time, then the service life of the combustion engine will be greatly reduced, indirectly affecting the work efficiency.Then how should we go to the daily maintenance of good combustion machine parts?Should notice to maintain what fittings?
According to the previous experience, the combustion engine accessories most pay attention to the maintenance of the place there are four aspects of the steps.
1. Pre-decompose the burner
First, let off the oil from the heating tank of the burner.Then remove the power cord and the connecting end of the air pipe, oil pipe, oil pump motor power cord, etc.Then take out the burner.Unscrew the screws on the bottom of the filter tank to release excess oil.Then unscrew the middle part of the filter cover, open the filter cover and take out the filter screen.At this time the combustion parts to clean the place has been decomposed.
2. Clean burner parts
First of all, remove the fouling on the flame plate, the gap should be ventilated.The carbon deposition on the electrode must be cleaned in time.Then clean the nozzle, nozzle, tubing and suction tubing with degreaser cleaner.If fouling is encountered on tubing or suction tubing walls, use wood sticks that can be inserted to clean.Check whether the combustion accessories O ring is in good condition, when necessary, should be replaced in time.When cleaning oil stains on heating wires and temperature sensors.Remember to clean the sludge at the bottom of the heated oil pool.Clean the filter tank and screen.Drain the oil from the tank, clean the bottom of the sludge, and clean the tank.
3. Reassembly shall be reverse assembled
What does reverse assembly mean?When installing the electrodes, we usually install the electrodes closely in accordance with the routine. If it is easy to cause the fault of the burner, we should pay attention to keep the gap between the electrodes at a distance of 3mm, and then add oil to the heating tank column until it reaches the standard level.
Here again remind you that the general combustion parts cleaning cycle in 2-3 weeks.
