LMG220 series gas burner controller

  Parts     |      2020-08-07 16:19
gas burner controller
Technical performance and structural characteristics:
 
Small (less than 350KW) burners based on microprocessor-controlled single-stage or dual-stage gas or gas/oil intermittent operation. With remote reset, low voltage monitoring, air pressure detection, fault code indication and other control functions.
 
●Series controller, integrated gas burning control function, suitable for automatic control of intermittent combustion.
 
●Used for monitoring and control of one-stage or two-stage gas or oil/gas burners during start-up and intermittent operation. According to the selected control type, its flame monitoring is through ionizing rods, a blue flame detector QRC1. with forced ventilation fuel/gas burners or a UV flame detector (with auxiliary equipment AGQ2 …A27).
 
●Low voltage monitoring. Air pressure detection.
 
●Comply with EN 676 automatic forced ventilation burner.
 
●Gas burner controller in accordance with EN 298.
 
●Gas burner controller in accordance with EN 298.
 
●LGB series controller, if need to use ultraviolet photoelectric tube to detect flame, need to be equipped with auxiliary components:
 
  AGQ1.1A27 (Cable length 500mm)
 
  AGQ1.2A27 (Cable length 300mm)
 
Installation Precautions:
 
1. The controller unit and other cables must be installed separately from the high-voltage ignition cables.
 
2. Don't confuse the live wire and the neutral wire.
 
3. The installation of switches, fuses, grounding, etc. must comply with local regulations.
 
4. It must be confirmed that the maximum current allowed by the terminal is not exceeded. 
 
5. Do not connect the main power supply to the output terminal of the combustion controller.
 
6. Use an all-polar switch to isolate the combustion controller from the mains power supply, leaving at least a 3mm contact gap.
 
7. Use a metric screw and loose washer to protect the ground sleeve under the chassis.

HOT PRODUCT


Message Feedback